Edge Banding Calculator

Enter each part, tap the edges that get banding, and see how much to order.

To know how much edge banding to buy, add up the length of every edge that gets banding, add an overhang at both ends of each strip for trimming, and round up to whole rolls. One 800 × 400 mm panel banded on all four edges with a 15 mm overhang needs 2 × 830 + 2 × 430 = 2,520 mm, so 2.52 m. With 1 mm banding the panel is cut at 798 × 398 mm, so that it finishes at 800 × 400.

How it's calculated

Each banded edge counts at its own length plus the overhang at both ends. The total is rounded up to the next centimetre, and the number of rolls is the total divided by the roll length, rounded up. The cut size takes the banding thickness off once for every banded edge on that side, the same way CutPlan does when it lays out your parts.

per part  = edges along L × (L + 2 × overhang)
          + edges along W × (W + 2 × overhang)
total     = Σ qty × per part
rolls     = ⌈ total ÷ roll length ⌉
cut size  = (L − edges along W × thickness) × (W − edges along L × thickness)

Millimetres or inches

Switch the calculator to inches and it takes lengths in inches and the roll in feet, and gives the length to order in feet. Roll lengths differ by supplier, so type the one you buy.

From banding to a cutting plan

The button under the result opens your parts in CutPlan's free cut list optimizer with the banding on each edge, so the layout uses the cut sizes. Parts typed in inches open at their exact size in millimetres. CutPlan tests over 100 strategies on every calculation, and calculating is free with no account needed, 30 calculations a month.

Open the cut list optimizer

Questions

How much edge banding do I need for a cabinet?

Add up every edge that gets banding on every part, add an overhang at both ends of each strip, and round up to whole rolls. Enter each part above with its quantity and tap its banded edges, and the calculator adds them up and shows the rolls. With a 15 mm overhang, a single 800 × 400 mm panel banded all round takes 2.52 m.

How much overhang should I leave on edge banding?

10 to 15 mm at each end is common for iron-on banding, so each strip can be trimmed flush after it is applied. The calculator starts at 15 mm; change it in its settings under the result.

Does edge banding change the cut size of the part?

Yes, by the banding thickness on every banded edge. A part banded on both long edges with 1 mm banding is cut 2 mm narrower, so it finishes at the size on your drawing. With banding under 1 mm, many shops cut to the finished size instead.

Related

Stop Wasting Sheets. Start Cutting Smarter.

Paste or import your cut list, let the optimizer do the math, and export production-ready layouts in seconds.

Start Optimizing — Free

See pricing