Enter the sheet length, the part length and your blade's kerf, and see how many parts really fit.
Every cut removes the width of the blade, the kerf, so parts that fill a sheet exactly on paper do not all fit. The number that fits is (sheet length + kerf) divided by (part length + kerf), rounded down. On a 2,440 mm sheet with a 3.2 mm kerf, eight 305 mm parts fit on paper, because 8 × 305 = 2,440, but only seven fit at the saw: the eighth comes out 22.4 mm short. In inches it is the same story: eight 12 inch parts from a 96 inch sheet with a 1/8 inch blade leave the eighth 7/8 inch short.
Between n parts there are n − 1 cuts, and one more cut frees the last part from the offcut, if anything is left. Each cut takes one kerf from the sheet. In the example, seven parts need seven cuts: 22.4 mm goes to the blade and a 282.6 mm offcut is left. Make the part 300 mm instead and all eight fit, with eight cuts and 14.4 mm left over.
parts = ⌊ (sheet + kerf) ÷ (part + kerf) ⌋ lost = kerf × cuts offcut = sheet − parts × part − lost
Switch the calculator to inches and type decimals: 1/8 inch is 0.125. The blade buttons then enter 1/8 inch for a full-kerf blade, 3/32 inch for a thin-kerf blade, and 0.0866 inch, the track saw's 2.2 mm.
The button under the result opens the sheet, the part and your kerf in CutPlan's free cut list optimizer, in the unit you chose, and shows the extra sheet when the kerf costs one. Add the rest of your parts there: CutPlan counts the kerf on every cut and tests over 100 strategies on every calculation. Calculating is free with no account needed, 30 calculations a month.
Leave one kerf between every two parts and one more where the last part is freed from the offcut. A cut list optimizer does it for you: enter the kerf once and every layout leaves room for each cut. In CutPlan the kerf is a setting of the project.
About 3.2 mm (1/8 inch) for a full-kerf blade, about 2.4 mm (3/32 inch) for a thin-kerf blade, and about 2.2 mm for a track saw. Blades differ by maker, so for the exact number cut a piece of scrap and measure the slot.
It can. In the example above the eighth part no longer fits, so a job that needs eight of those parts needs a second sheet. Across a whole cut list the kerf adds up the same way, which is why the optimizer counts it on every cut.
Paste or import your cut list, let the optimizer do the math, and export production-ready layouts in seconds.